Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR FLOOR AIRBAG SENSOR
RM2090E _58 Vehicle Interior _060701 SUPPLEMENTAL RESTRAINT SYSTEMS _0297716 REAR FLOOR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR FLOOR AIRBAG SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing. (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.


Hide 58810J 3.REMOVE CONSOLE BOX ASSEMBLY

Hide 89970 4.REMOVE NO. 2 AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

NOTICE:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



c.
B311411E01
1.044,2.059 1.264,2.253 0.220,0.194 10 *1 0.696,2.458 1.028,2.163 false

Remove the bolt.

NOTICE:

Loosen the bolt while holding the No. 2 airbag sensor assembly because the No. 2 airbag sensor assembly pin (stopper) is easily damaged.


Text in Illustration
*1 Outer Housing


d.

Slide the outer housing to release the lock, and then disconnect the connector to remove the No. 2 airbag sensor assembly.

NOTICE:

When disconnecting airbag connector, take care not to damage the airbag wire harness.