Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2090E _58 Vehicle Interior _060703 SEAT BELT _0297727 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.


Hide 62312B 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the front door opening trim weatherstrip.


Hide 64715D 5.REMOVE LUGGAGE COMPARTMENT TRIM COVER

Hide 62606A 6.REMOVE QUARTER TRIM LID SUB-ASSEMBLY

Hide 62462A 7.REMOVE REAR WINDOW SIDE GARNISH

Hide 62639 8.REMOVE REAR QUARTER TRIM FRONT GARNISH

Hide 73220 9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B311331E01
0.476,0.375 0.719,0.595 0.244,0.221 10 *1 0.69,0.454 1.29,0.673 false

Turn back the floor anchor cover.

Text in Illustration
*1 Floor Anchor Cover


b.

Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly.


Hide 73220 11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B311332

Loosen the bolt and disconnect the shoulder anchor of the front seat outer belt assembly.


b.
B311333E01
0.522,0.828 0.981,1.261 false 0.809,2.272 1.272,2.171 false 0.748,0.448 1.041,0.82 false 0.345,0.72 0.531,0.881 0.186,0.161 10 *1 1.302,2.1 1.488,2.261 0.186,0.161 10 *3 0.609,0.265 0.795,0.426 0.186,0.161 10 *2

Using a screwdriver with the tip wrapped with protective tape, release the pretensioner connector lock and disconnect the pretensioner connector.

Text in Illustration
*1 Protective Tape
*2 Pretensioner Connector
*3 Pretensioner Connector Lock

HINT:

Tape the screwdriver tip before use.



c.
B311334

Remove the 2 bolts and disengage the hook to remove the front seat outer belt assembly.