ACTUATOR CHECK
Start the engine and warm it up.
Perform the indicator check (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DIAGNOSIS SYSTEM).
After the indicator check is completed the system enter the DTC check mode automatically.
Press the "A/C" switch to cancel the check mode.
Push the "DEF" switch to perform the actuator check.
Be sure to perform the actuator check after starting the engine.
As the actuator check is repeated from steps 1 to 8 at 1 second intervals, check the temperature and air flow visually and by hand.
The display blinks at 1 second intervals in the step operation.
Push the "OFF" switch to finish panel diagnosis.
Push the "AUTO" switch to enter the sensor check mode.
| Step No. | Display Code | Conditions | ||||
|---|---|---|---|---|---|---|
| Blower Level | Air Mix Damper | Airflow Vent | Air Inlet Damper | Compressor | ||
| 1 | 81 | L0 | 0% open | FACE | FRESH | OFF |
| 2 | 82 | L0 | 0% open | FACE | RECIRCULATION / FRESH | ON |
| 3 | 83 | M1 | 0% open | FACE | RECIRCULATION / FRESH | ON |
| 4 | 84 | M1 | 50% open | B/L | FRESH | ON |
| 5 | 85 | M1 | 50% open | FOOT | FRESH | ON |
| 6 | 86 | M3 | 100% open | FOOT | FRESH | ON |
| 7 | 87 | M3 | 100% open | F/D | FRESH | ON |
| 8 | 88 | Hi | 100% open | DEF | FRESH | ON |
If the steps are difficult to read because they change automatically, push the "A/C" switch to display the steps one at a time so that they can be read easily. The items are displayed step by step each time the "A/C" switch is pushed.
Push the "OFF" switch to finish panel diagnosis.
Push the "AUTO" switch to enter the sensor check mode.