In this circuit, the air conditioning control assembly receivers engine coolant temperature signals from the ECM using the CAN communication system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| E24 | ·
Ignition switch : ON ·
Engine coolant temperature data is interrupted for 0.5 second. |
·
Engine coolant temperature sensor ·
Harness or connector between Engine coolant temperature sensor and ECM ·
ECM ·
air conditioning control assembly ·
CAN communication system |
If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI System (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR)
DTC is not output.
OK
NG
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to force the A/C system to output DTCs by simulating the conditions indicated the DTC.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC E24 is output | B |
A
B