Use the same procedure for the LHD and RHD vehicle.
The procedure listed below is for the LHD vehicle.
74221
1.REMOVE DOOR ARMREST COVER RH
Use the same procedure as for the LH side (See page Vehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY).
67601
2.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
Use the same procedure as for the LH side (See page Vehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY).
3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
84810
4.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the power window regulator switch assembly.
| *1 | Protective Tape |