Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › 2012.03–2016.06
RM2090E _59 Vehicle Exterior _060710 WIPER / WASHER _0297787 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 84650 1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

a.
B314883

Engage the claw and install the windshield wiper switch assembly as shown in the illustration.


b.

Connect the connector.


Hide 45025D 2.INSTALL UPPER STEERING COLUMN COVER

a.

Engage the 4 claws and install the upper steering column cover.


Hide 45286 3.INSTALL LOWER STEERING COLUMN COVER

a.

w/ Knee Airbag

i.

Engage the 4 claws to install the lower steering column cover.



b.

w/o Knee Airbag

i.

Engage the 6 claws to install the lower steering column cover.



c.

While turning the steering wheel assembly to the right and left, install the 2 screws.


Hide 45289A 4.INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

a.

Engage the 4 claws and install the steering column cover support.


Hide 55606 5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)

Hide 55422 7.INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT

Hide 55405B 9.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY