Use the same procedure for the LHD and RHD vehicle.
The procedure listed below is for the LHD vehicle.
55318C
1.REMOVE INSTRUMENT SIDE PANEL LH
55405B
2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55403
3.REMOVE METER HOOD SUB-ASSEMBLY
55422
4.REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
55606
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)
45289A
7.REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)
Disengage the 4 claws and remove the steering column cover support.
45286
8.REMOVE LOWER STEERING COLUMN COVER
While turning the steering wheel assembly to the right and left, remove the 2 screws.
w/ Knee Airbag
Disengage the 4 claws and remove the lower steering column cover.
w/o Knee Airbag
Disengage the 6 claws and remove the lower steering column cover.
45025D
9.REMOVE UPPER STEERING COLUMN COVER
Disengage the 2 claws and remove the upper steering column cover.
84650
10.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Disconnect the 2 connectors.
Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
| *1 | Protective Tape |
Do not press the claw too hard, as it mat get damaged.
Tape the screwdriver tip before use.