Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
85208A
1.INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY
Install the headlight washer actuator sub-assembly with the bolt.
Install the clip.
Connect the headlight washer hose and joint clamp.
52119A
2.INSTALL FRONT BUMPER COVER
3.ADD WASHER FLUID
4. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT (w/ Fog Light)
5. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light)
6.INSPECT FOG LIGHT AIMING (w/ Fog Light)
7.ADJUST FOG LIGHT AIMING (w/ Fog Light)