Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
81720
1.INSTALL FRONT MARKER LIGHT ASSEMBLY
Connect the connector.
Engage the claw to install the front marker light assembly.
Check that the side front marker light assembly is installed securely.
If the front marker light assembly is not installed securely, widen and adjust the claw.
| Area | Specified Condition |
|---|---|
| a | 3.0 mm (0.118 in.) |
| *1 | Front Marker Light Assembly |
| *2 | Claw |
53876A
2.INSTALL FRONT FENDER LINER