Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM2090E _51 Engine / Hybrid System _060673 CRUISE CONTROL _0297540 CRUISE CONTROL SYSTEM Y

CRUISE CONTROL  CRUISE CONTROL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the cruise control system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
3.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
a.

Use the GTS to check if the CAN communication system is functioning normally.


Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output B



A

4.CHECK FOR DTC*

B

4.CHECK FOR DTC*

Refer to DTC Check / Clear.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

a.

Check for DTCs and note any codes that are output.


b.

Clear the DTCs.


c.

Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.


Result:
Result Proceed to
DTC does not reoccur A
DTC reoccurs B



A

5.ROAD TEST

B

5.ROAD TEST

b.

Check that cruise control is not canceled by other than canceling operations by the driver.


Result:
Result Proceed to
Cruise control is cancelled A
Cruise control is not cancelled B



A

6.CHECK "CANCEL CODE"*

B

8.OVERALL ANALYSIS AND TROUBLESHOOTING*
6.CHECK "CANCEL CODE"*
HINT:

The driver's history of canceling cruise control is also stored.



Result:
Result Proceed to
"CANCEL CODE" is not detected A
"CANCEL CODE" is detected B



A

7.PROBLEM SYMPTOMS TABLE

B

ADJUST, REPAIR OR REPLACE ACCORDING TO "CANCEL CODE"

7.PROBLEM SYMPTOMS TABLE

Refer to Problem Symptoms Table.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

9.ADJUST, REPAIR OR REPLACE
9.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

10.CONFIRMATION TEST
10.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END