Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2017.03
RM2090E _52 Drivetrain _060678 AXLE AND DIFFERENTIAL _0297588 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 89546 2.SEPARATE REAR SPEED SENSOR LH

a.
C257477

Remove the bolt and separate the rear speed sensor LH.

NOTICE:

Prevent foreign matter from attaching to the sensor tip.



Hide 42312B 3.REMOVE REAR AXLE SHAFT NUT LH

C259939

a.

Using SST and a hammer, release the staked part of the rear axle shaft nut.

SST
09930-00010  

NOTICE:
·

Do not grind the SST.

·

Release the staked part of the nut completely; otherwise the threads of the drive shaft may get damaged.




b.

Remove the rear axle shaft nut.


Hide 47810A 4.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42450B 6.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH

a.

Using a plastic-faced hammer, disconnect the rear drive shaft assembly from the rear axle hub and bearing assembly LH.

NOTICE:
·

Be careful not to damage the boot.

·

Use a wire or equivalent to prevent the rear drive shaft assembly from hanging down.




b.
C259944

Remove the 4 bolts and the rear axle hub and bearing assembly LH from the rear axle assembly.