Home › Brake › BRAKE (REAR) › REAR BRAKE (for Opposed Type Caliper) › from 2017.03
RM2090E _54 Brake _060687 BRAKE (REAR) _0313979 REAR BRAKE(for Opposed Type Caliper) G

BRAKE (REAR)  REAR BRAKE(for Opposed Type Caliper)  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C262317

Using a ruler, measure the rear disc brake pad lining thickness.

Standard Thickness:

9.0 mm (0.354 in.)


Minimum Thickness:

1.2 mm (0.0472 in.)


If a rear disc brake pad lining thickness is less than the minimum thickness, replace the rear disc brake pads.

HINT:

Be sure to check rear disc thickness when replacing the rear disc brake pads with new ones.



Hide 42431 3.INSPECT DISC THICKNESS

a.
C256658

Using a micrometer, measure the rear disc thickness.

Standard Thickness:

20.0 mm (0.787 in.)


Minimum Thickness:

18.0 mm (0.709 in.)


If the rear disc thickness is less than the minimum thickness, replace the rear disc.


Hide 4.INSPECT DISC RUNOUT

a.
C375877E01
0.979,1.854 1.573,1.854 true 0.771,1.771 0.948,1.969 0.177,0.198 10 false *1

Check the bearing play in the axial direction and check for the axle hub runout (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>ON-VEHICLE INSPECTION).


b.

Tighten the disc with the 5 nuts.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)


c.

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.

Text in Illustration
*1 Dial Indicator

Maximum disc runout:

0.07 mm (0.0028 in.)


NOTICE:
·

If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, replace the rear disc.




d.

Remove the 5 hub nuts and rear disc.


e.
C364392E01
2.604,1.125 2.885,0.844 false 2.927,0.698 3.198,0.896 0.271,0.198 10 false *1

Set the dial indicator 10 mm (0.394 in.) inside the rear disc outer circumference, and then rotate the rear disc to check the runout at the back.

Text in Illustration
*1 Dial Indicator

Maximum disc runout:

0.07 mm (0.0028 in.)


HINT:

The illustration shows an example.