Heated oxygen sensor refers to the sensor closest to the engine assembly.
Refer to DTC P0130 (See page Engine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>P0130).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0135 | Oxygen (A/F) Sensor Heater Circuit Malfunction (Bank 1 Sensor 1) | Open or short in heated oxygen sensor heater circuit for 1.28 seconds or more
(1 trip detection logic) |
·
Open or short in heated oxygen sensor heater circuit ·
Heated oxygen sensor heater ·
ECM |
Comes on | DTC stored |
Refer to DTC P0130 (See page Engine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>P0130).
Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
Inspect the heated oxygen sensor.
Click hereEngine / Hybrid System>K3-VE ENGINE CONTROL>HEATED OXYGEN SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(ECM) |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connections | Switch Condition | Specified Conditions |
|---|---|---|
| C24-3 (OXH1) - C24-32 (E1) | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the heated oxygen sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C24-3 (OXH1) - C22-1 (HTR-) | Always | Below 1 Ω |
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C24-3 (OXH1) or C22-1 (HTR-) - Body ground | Always | 10 kΩ or higher |
Reconnect the heated oxygen sensor connector.
Reconnect the ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the heated oxygen sensor connector.
Remove the EFI MAIN relay from the fuse block.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C22-2 (HTR+) - EFI MAIN relay (5) | Always | Below 1 Ω |
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C22-2 (HTR+) or EFI MAIN relay (5) - Body ground | Always | 10 kΩ or higher |
Reconnect the heated oxygen sensor connector.
Reinstall the EFI MAIN relay.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C