Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › THROTTLE BODY › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014974 THROTTLE BODY A

3SZ-VE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22210 1.INSTALL THROTTLE BODY ASSEMBLY

a.

Install a new O-ring onto the intake manifold.


b.

Apply a light coat of fresh engine oil to the O-ring or throttle body assembly.


c.

Install the throttle body assembly with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 16 ft.*lbf)


d.

Install the engine wire harness bracket onto the throttle body assembly with the bolt.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)


e.

Install the No. 2 throttle body bracket with the 2 bolts.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)


f.

Connect the No. 2 ventilation hose to the throttle body assembly.


g.

Connect the idle speed control valve connector.


h.

Connect the throttle position sensor connector.


i.

Connect the No. 1 water by-pass hose and No. 2 water by-pass hose (w/ heater hose).


Hide 78180P 2.CONNECT ACCELERATOR CONTROL CABLE ASSEMBLY

a.
A133502

Tighten the nut shown in the illustration to connect the accelerator control cable.


Hide 5.ADD ENGINE COOLANT (w/ Heater Hose)