The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to the ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned to the ON the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure.
Perform troubleshooting in accordance with the chart below.
| Result | Proceed to |
|---|---|
| MIL remains ON | A |
| MIL does not illuminate | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Check whether any DTCs have been stored. Note down any DTCs.
Clear DTCs.
Check whether the MIL turns off.
MIL should turn off.
If the system has any malfunctions (the ECM stores any DTCs), troubleshoot those DTCs and repair them first.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Rear view of wire harness connector
(to ECM) |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
MIL is not illuminated.
Reconnect the ECM connector.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| E3-27 (W) or E34-37 (EFI) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the combination meter assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check whether the MIL illuminates when turning the ignition switch to ON.
MIL should illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch to ON.
Start the engine.
| Result | Proceed to |
|---|---|
| Engine starts | A |
| Engine does not start* | B |
*: An intelligent tester cannot communicate with the ECM.
A
B
See the combination meter troubleshooting procedure.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Check the resistance.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| E3-27 (W) - E34-37 (EFI) | Always | Below 1 Ω |
Reconnect the ECM connector.
Reconnect the combination meter assembly connector.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C