The transponder key computer assembly (immobiliser ECU) ensures security by controlling the START/END of the communication of matching codes with the ECM. It does so in accordance with the ignition ON/OFF status and the immobiliser SET/ UNSET status.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0167 | Lost Communication with Vehicle Immobiliser Control Module | Communication problem with transponder key ECU assembly (immobiliser ECU) or code mismatch
(1 trip detection logic) |
·
Engine immobiliser system ·
Transponder key ECU assembly (immobiliser ECU) ·
Open or short in communication line (wire harness or connector) ·
ECM |
- | DTC stored |
This DTC is output when: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; and 3) the ECU communication IDs between the transponder key ECU and the ECM are different when an engine start is attempted.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTC.
Turn the ignition switch off, then turn the ignition switch to ON again.
Start the engine.
Enter the following menus: Powertrain / Engine / Trouble codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| U0167 | A |
| No DTC output | B |
| U0167 and other DTCs | C |
If any transponder key ECU DTC is present, refer to its inspection procedure first.
A
B
C
Disconnect the transponder key ECU connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| E58-9 (SIO2) - E3-32 (SIO2) | Always | Below 1 Ω |
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| E58-9 (SIO2) or E3-32 (SIO2) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the transponder key ECU connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTC.
Reregister the key (key ID code).
| Proceed to |
|---|
| NEXT |
NEXT
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Start the engine.
Enter the following menus: Powertrain / Engine / Trouble codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| U0167 (engine cannot start) | A |
| No DTC output (engine start) | B |
A
B
Replace with a new or a known-good ECM.
Click hereEngine / Hybrid System>3SZ-VE ENGINE CONTROL>ECM(for LHD)>REMOVAL
Replace with a new or a known-good ECM.
Click hereEngine / Hybrid System>3SZ-VE ENGINE CONTROL>ECM(for RHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Start the engine.
Enter the following menus: Powertrain / Engine / Trouble codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| U0167 (engine cannot start) | A |
| No DTC output (engine start) | B |
A
B