The ECM intercommunicates with the TCM and the combination meter assembly through the Controller Area Network (CAN).
If the ECM cannot communicate with the TCM and/or the combination meter assembly, the ECM sets a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0001 | High Speed CAN Communication Bus | No communication between ECM, combination meter and TCM for 2 second or more
(1 trip detection logic) |
·
Open or short in TCM, ECM and combination meter circuit ·
TCM ·
Combination meter assembly ·
ECM |
Comes on | DTC stored |
| U0101 | Lost Communication with TCM | Either of following condition met:
(1 trip detection logic) ·
No communication from TCM (reception) for 1 second or more ·
No communication from ECM (transmission) for 0.3 seconds or more |
·
Open or short in TCM and ECM circuit ·
TCM ·
ECM |
Comes on | DTC stored |
| U0156 | Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) | No communication from combination meter (reception) for 1 second or more
(1 trip detection logic) |
·
Open or short in combination meter and ECM circuit ·
Combination meter assembly ·
ECM |
Comes on | DTC stored |
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester or Techstream on.
Clear the DTCs.
Start the engine.
Drive the vehicle.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
|---|---|
| U0001, U0101 or U0156 | A |
| No output | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B