Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › SFI SYSTEM(w/ Rear Heated Oxygen Sensor) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014988 SFI SYSTEM(w/ Rear Heated Oxygen Sensor) C

3SZ-VE ENGINE CONTROL  SFI SYSTEM(w/ Rear Heated Oxygen Sensor)  P1105  Atmospheric Pressure Sensor Signal  


DESCRIPTION

The atmospheric pressure sensor is built into the ECM.

HINT:

When DTC P1105 is set, the ECM enters fail-safe mode. During fail-safe mode, the ECM uses a constant value stored in the ECM memory as an atmospheric pressure sensor signal. Fail-safe mode continues until a pass condition is detected.


DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P1105 Atmospheric Pressure Sensor Signal No signal from atmospheric pressure sensor for 0.5 seconds after engine starts.
(1 trip detection logic)
ECM Comes on DTC stored

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the intelligent tester or Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC P1105)
a.

Connect the intelligent tester or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester or Techstream on.


d.

e.

Start the engine.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 206

g.

Read DTCs.

Result:
Result Proceed to
No output A
P1105 (for LHD) B
P1105 (for RHD) C




A

B

C