Home › Engine / Hybrid System › K3-VE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002970 K3-VE ENGINE MECHANICAL _0015007 FRONT CRANKSHAFT OIL SEAL A

K3-VE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN OR BELT COVER OIL SEAL

a.

Apply MP grease to a new timing chain or belt cover oil seal lip.


b.
A107955N04
0.844,0.167 1.24,0.646 true 2.583,0.115 2.969,0.458 0.385,0.344 10 - 3.188,0.135 3.427,0.427 0.24,0.292 10 + 0.49,0.083 1.083,0.469 0.594,0.385 10 SST

Using SST and a hammer, tap in the new timing chain or belt cover oil seal until its surface is flush with the timing chain cover edge.

SST
09608-06041  

NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap the timing chain cover oil seal at an angle.



HINT:
Oil seal tap in depth:

-0.5 to 1.0 mm (-0.0197 to 0.0394 in.)



Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.

Align the key with the key groove of the crankshaft pulley, and install the crankshaft pulley to the crankshaft.


b.

Using SST, secure the crankshaft pulley.

SST
09330-00021  
09213-54015  (91651-60855)

SST
09330-00021  


c.

Tighten the bolt to the specified torque.

Torque:
140 N*m (1428 kgf*cm, 103 ft.*lbf)


Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT

Hide 16361A 4.ADJUST FAN AND GENERATOR V BELT

Hide 16400 5.INSTALL RADIATOR ASSEMBLY