Home › Engine / Hybrid System › K3-VE COOLING › RADIATOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002977 K3-VE COOLING _0015048 RADIATOR A

K3-VE COOLING  RADIATOR  INSTALLATION  


PROCEDURE

Hide 16400 1.INSTALL RADIATOR ASSEMBLY

a.

Install the 4 grommets onto the radiator.


b.
A261285

Engage the 2 claws and install the fan shroud sub-assembly (for Narrow radiator).


c.

Install the fan shroud sub-assembly with fan with the 4 bolts (for Full wide radiator).

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


d.

Install the radiator assembly into the vehicle.


e.

Install the No. 1 radiator brackets with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


f.

Connect the accelerator control cable assembly to the fan shroud sub-assembly.


g.

Connect the clutch cable to the clutch cable bracket.


h.

Connect the cooling fan motor connector, then install the wire harness clamp.


Hide 32941 2.CONNECT INLET OIL COOLER HOSE (for Automatic Transmission)

a.

Connect the inlet oil cooler hose.


Hide 32942 3.CONNECT OUTLET OIL COOLER HOSE (for Automatic Transmission)

a.

Connect the outlet oil cooler hose.


Hide 16572 4.INSTALL OUTLET RADIATOR HOSE

a.

Connect the outlet radiator hose.


Hide 16571 5.INSTALL INLET RADIATOR HOSE

a.

Connect the inlet radiator hose with the 2 radiator hose clips.


b.

Connect the accelerator cable clamp.


Hide 16470A 6.INSTALL RADIATOR RESERVE TANK HOSE

a.

Connect the radiator reserve tank hose.


Hide 11.INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK