Home › Engine / Hybrid System › K3-VE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002970 K3-VE ENGINE MECHANICAL _0015008 REAR CRANKSHAFT OIL SEAL A

K3-VE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

Hide 3.REMOVE TRANSMISSION ASSEMBLY (for Manual Transmission)

Hide 31210 4.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 31250 5.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 13405 6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

Hide 11381A 7.REMOVE REAR ENGINE OIL SEAL

a.
A107948C03
1.563,0.708 2.01,0.271 true 0.427,1.271 1.094,1.646 true 3.104,1.365 3.146,1.604 true 0.208,1.156 0.531,1.458 0.323,0.302 10 *2 2.021,0.104 2.406,0.417 0.385,0.313 10 *1 3.063,1.625 3.427,1.948 0.365,0.323 10 *a
*1 Protective Tape
*2 Piece of Cloth
*a Cut Position


Using a knife, cut off the rear engine oil seal lip.


b.

Using a screwdriver with its tip wrapped in protective tape, remove the rear engine oil seal.

NOTICE:

After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.