Home › Engine / Hybrid System › 3SZ-VE FUEL › FUEL INJECTOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002971 3SZ-VE FUEL _0015017 FUEL INJECTOR A

3SZ-VE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 22210 2.REMOVE THROTTLE BODY ASSEMBLY

Hide 12261 3.REMOVE VENTILATION HOSE

a.
A126547

Disconnect the ventilation hose from the ventilation valve.


Hide 4.REMOVE NO. 2 FUEL PIPE CLAMP

a.
A261191

Remove the No. 2 fuel pipe clamp.


Hide 5.DISCONNECT FUEL TUBE SUB-ASSEMBLY

a.
A261192

Pinch the tube connector and pull out the fuel pipe (See page Engine / Hybrid System>3SZ-VE FUEL>FUEL SYSTEM>PRECAUTION).

NOTICE:
·

Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.

·

The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.

·

If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.

·

Do not use any tools.

·

Do not bend or twist the tubes.

·

Protect the contact surface by covering it with a plastic bag.

·

Do not damage any of the clips. If a clip is damaged, replace it.




Hide 23807 6.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

A265517

a.

Disengage the 2 clamps of the engine wire.


b.

Disconnect the 4 fuel injector connectors.


c.
A126550

Remove the 2 bolts, then remove the fuel delivery pipe together with the fuel injector.

NOTICE:

Do not drop the fuel injector when removing the fuel delivery pipe.



Hide 23845C 7.REMOVE FUEL PIPE INSULATOR

a.
A263479

Remove the 2 fuel pipe insulators.


Hide 23250 8.REMOVE FUEL INJECTOR ASSEMBLY

a.
A126551

Remove the 4 fuel injectors from the fuel delivery pipe.


b.
A261195

For reinstallation, attach a tag or label to each injector shaft.

NOTICE:

Prevent entry of foreign objects by covering the fuel injectors with plastic bags.



Hide 23291 9.REMOVE INJECTOR VIBRATION INSULATOR

a.
A261193

Using a screwdriver, remove the 4 injector vibration insulators from the cylinder head.