11452
1.REMOVE OIL LEVEL DIPSTICK GUIDE
2.DRAIN MANUAL TRANSMISSION OIL
37100
3.REMOVE PROPELLER SHAFT ASSEMBLY
17410
4.REMOVE FRONT EXHAUST PIPE ASSEMBLY
5.SEPARATE CLUTCH RELEASE CABLE ASSEMBLY
33820B
6.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
7.DISCONNECT CONNECTOR
33110
8.SUPPORT MANUAL TRANSMISSION ASSEMBLY
Support the manual transmission assembly with a transmission jack.
51022
9.REMOVE REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY
Remove the 6 bolts and the rear engine support member sub-assembly.
28100
10.REMOVE STARTER ASSEMBLY
Tilt the engine and manual transmission assembly by gradually lowering the transmission jack until the bolts can be seen.
Do not tilt the manual transmission assembly more than necessary.
Disconnect the starter connector.
Remove the nut, then disconnect the engine wire.
Disengage the clamp of the backup light switch.
Hold the transmission.
Remove the 2 bolts and the starter assembly with the transmission inclined.
Use a union nut wrench to loosen the lower bolt.