Home › Drivetrain › A4Q AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002983 A4Q AUTOMATIC TRANSMISSION / TRANSAXLE _0015082 SHIFT LEVER A

A4Q AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  INSTALLATION  


PROCEDURE

Hide 33504F 1.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

a.

Install the shift lever knob sub-assembly to the transmission floor shift assembly.


Hide 33550 2.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

a.
C234754C02
2.115,1.854 2.781,2.177 0.667,0.323 10 1 (*a), 3 0.51,0.281 1.406,0.667 0.896,0.385 10 2 (*a), 4 0.646,1.792 1.146,2.177 0.5,0.385 10 5 2.531,0.167 3.042,0.542 0.51,0.375 10 6
*a Temporarily


Install the transmission floor shift assembly and tighten the 4 bolts in the order shown in the illustration.

Torque:
18 N*m (185 kgf*cm, 13 ft.*lbf)


b.

Connect the connector.


Hide 3.INSTALL SHIFT LOCK CONTROL ECU

a.

Engage the 3 claws and install the shift lock control ECU to the transmission floor shift assembly.


b.

Connect the 2 connectors.


Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C234753N02
0.382,1.259 0.552,1.429 0.17,0.17 10 A

Connect the transmission control cable assembly and install the 2 clips.

NOTICE:

Be sure to use a new clip at position A.



Hide 9.INSTALL FRONT SEAT ASSEMBLY RH

Hide 10.INSTALL FRONT SEAT ASSEMBLY LH

HINT:

Use the same procedure for the front seat assembly RH.