Home › Drivetrain › M5S MANUAL TRANSMISSION / TRANSAXLE › SHIFT LEVER ASSEMBLY › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002985 M5S MANUAL TRANSMISSION / TRANSAXLE _0015104 SHIFT LEVER ASSEMBLY A

M5S MANUAL TRANSMISSION / TRANSAXLE  SHIFT LEVER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 33606 1.REMOVE WIRE PULL LEVER SUB-ASSEMBLY

a.

Install the wire pull lever sub-assembly with the 2 bolts to the floor shift control link support.

Torque:
22 N*m (220 kgf*cm, 16 ft.*lbf)


Hide 33550 2.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

a.
C150619N01
1.042,1.835 1.191,1.998 0.149,0.163 10 A 2.103,0.687 2.252,0.851 0.149,0.163 10 B 0.565,0.937 0.72,1.107 0.155,0.17 10 C 2.868,1.452 3.003,1.629 0.135,0.177 10 D

Install the transmission floor shift assembly in the following order.

i.

Temporarily tighten bolt A, then bolt B.


ii.

Fully tighten bolt A, then bolt B.


iii.

Tighten bolt C, then bolt D.

Torque:
18 N*m (185 kgf*cm, 13 ft.*lbf)



Hide 33829B 3.INSTALL TRANSMISSION CONTROL CABLE CLAMP

a.

Install the transmission control cable clamp with the bolt.

Torque:
18 N*m (185 kgf*cm, 13 ft.*lbf)


Hide 33504F 6.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 8.INSTALL FRONT SEAT ASSEMBLY RH

Hide 9.INSTALL FRONT SEAT ASSEMBLY LH

HINT:

Use the same procedure for the front seat assembly RH.