Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002986 DRIVE SHAFT / PROPELLER SHAFT _0015113 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 37100 1.TEMPORARILY TIGHTEN PROPELLER SHAFT ASSEMBLY

a.

Insert the propeller shaft assembly into the extension housing.

NOTICE:

Be careful not to damage the oil seal.



b.

Temporarily tighten the center support bearing bracket with the 4 bolts.


c.

Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange and differential flange.


d.

Align the matchmarks on the propeller shaft and differential flange.


e.

Install the propeller shaft with the 4 bolts and 4 washers.

Torque:
60 N*m (615 kgf*cm, 45 ft.*lbf)


Hide 37100 2.FULLY TIGHTEN PROPELLER SHAFT ASSEMBLY

a.

Lift the rear axle housing up with a jack and apply load to the suspension.


b.
C253310N02
1.823,1 2.052,0.74 true 2.083,0.615 2.594,1.052 0.51,0.438 10 90°

Check if the center line of the center support bearing bracket makes a right angle with the propeller shaft.


c.

Fully tighten the 4 bolts.

Torque:
37 N*m (375 kgf*cm, 27 ft.*lbf)


d.

Install the cable clamp with the bolt.

Torque:
18 N*m (185 kgf*cm, 13 ft.*lbf)


Hide 3.ADD MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 4.INSPECT MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 5.ADD AUTOMATIC TRANSMISSION FLUID (for Automatic Transmission)

Hide 6.INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL (for Automatic Transmission)

Hide 7.INSPECT FOR OIL LEAK