Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM19Y0E _52 Drivetrain _002987 AXLE AND DIFFERENTIAL _0015116 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512D 3.INSPECT FRONT AXLE HUB BEARING LH

C144890

a.

Inspect the axle hub backlash.

i.

Using a dial indicator, check the backlash near the center of the axle hub.

Maximum:

0.05 mm (0.0020 in.)


If the backlash exceeds the maximum, replace the bearing.



b.
C144891

Inspect the axle hub runout.

i.

Using a dial indicator, check the runout of the surface of the axle hub.

Maximum:

0.07 mm (0.0028 in.)


If the runout exceeds the maximum, replace the axle hub.



Hide 4.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 5.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)