Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE SHAFT
RM19Y0E _52 Drivetrain _002987 AXLE AND DIFFERENTIAL _0015118 REAR AXLE SHAFT G

AXLE AND DIFFERENTIAL  REAR AXLE SHAFT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 3.INSPECT REAR AXLE SHAFT BEARING

C145746

a.

Inspect the axle shaft backlash.

i.

Using a dial indicator, check the backlash near the center of the axle shaft.

Maximum:

0.8 mm (0.0315 in.)


If the backlash exceeds the maximum, replace the bearing.



b.
C145747

Inspect the axle shaft runout.

i.

Using a dial indicator, check the runout of the surface of the axle shaft.

Maximum:

0.05 mm (0.0020 in.)


If the runout exceeds the maximum, replace the bearing.



Hide 42403 4.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 42403 5.ADJUST REAR DRUM BRAKE SHOE CLEARANCE

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)