42403
1.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
2.ADJUST REAR DRUM BRAKE SHOE CLEARANCE
Provisionally install the wheel nuts.
Remove the hole plug.
| *1 | Automatic adjust lever |
|
Expand |
Turn and expand the adjuster. Contact the brake shoes with the rear brake drum sub-assembly.
| *1 | Automatic adjust lever |
|
Contract |
Push the automatic adjust lever using a screwdriver. Turn and contract the adjuster using another screwdriver.
Turn and contract the adjuster until the brake shoe does not contact the rear brake drum sub-assembly, and then turn the adjuster 180 degree more and contract.
Install the hole plug.
Remove the wheel nuts.
3. FILL RESERVOIR WITH BRAKE FLUID
4.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)
5.BLEED MASTER CYLINDER
6.BLEED BRAKE LINE
7. CHECK FLUID LEVEL IN RESERVOIR
8.INSPECT FOR BRAKE FLUID LEAK
9.INSTALL REAR WHEEL
10.ADJUST PARKING BRAKE LEVER TRAVEL