Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015140 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89546 1.INSTALL REAR SPEED SENSOR

NOTICE:
·

Do not twist the sensor wire when installing.

·

Make sure that the speed sensor is installed correctly.



a.

Install the rear speed sensor with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

NOTICE:
·

Check that the rear speed sensor tip and installation portion are free of foreign matter.

·

Install the rear speed sensor without turning it from its original installation angle.




b.

Connect the 2 clamps onto the rear axle housing.


c.

Install the sensor bracket onto the rear axle housing with the bolt.

Torque:
7.4 N*m (76 kgf*cm, 66 in.*lbf)


d.

Connect the 2 clamps to the upper arm.


e.

Install the sensor bracket onto the body with the bolt.

Torque:
7.4 N*m (76 kgf*cm, 66 in.*lbf)


f.

Install the grommet to the body.

NOTICE:

Make sure that the grommet is installed correctly.



g.

Connect the speed sensor connector.


Hide 2.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 64740C 3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)

HINT:

Use the same procedure as for the RH side.


Hide 73570 4.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY

(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)

HINT:

Use the same procedure as for the RH side.


Hide 67918E 7.INSTALL REAR DOOR SCUFF PLATE LH

(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)

HINT:

Use the same procedure as for the RH side.