45287
1.REMOVE LOWER STEERING COLUMN COVER
47101
2.INSPECT AND ADJUST BRAKE PEDAL
| *1 | Stop Light Switch |
| *2 | Push Rod |
| *3 | Lock Nut |
| *a | Pedal Height |
Inspect the brake pedal height.
129.0 mm (5.079 in.)
If the pedal height is incorrect, adjust it.
Adjust the brake pedal height.
Disconnect the connector from the stop light switch assembly.
Turn the stop light switch counterclockwise, and remove it.
Loosen the clevis lock nut.
Adjust the pedal height by turning the pedal push rod.
129.0 mm (5.079 in.)
Tighten the clevis lock nut.
| *1 | Adjuster |
| *2 | Cushion |
| *3 | Stop light switch |
Insert the stop light switch assembly into the adjuster until it just touches the stop light switch cushion.
Do not depress the brake pedal.
| *1 | Shaft |
| *2 | Stop light switch |
| *a | 0.2 to 2.8 mm
(0.008 to 0.110 in.) |
Turn the stop light switch 90° clockwise to install it.
Do not depress the brake pedal.
Check the stop light switch clearance.
0.2 to 2.8 mm (0.008 to 0.110 in.)
Connect the connector to the stop light switch assembly.
| *a | Pedal free play |
Inspect the brake pedal free play.
Stop the engine and depress the brake pedal several times until there is no vacuum left in the booster.
Push in the pedal until the beginning of the resistance is felt. Measure the distance as shown.
0.5 to 2.0 mm (0.020 to 0.079 in.)
If the brake pedal free play is not as specified, check the stop light switch clearance.
| *a | Pedal reserve distance |
Inspect the brake pedal reserve distance.
Release the parking brake lever. With the engine running, depress the pedal and measure the pedal reserve distance as shown.
More than 94 mm (3.7 in.) at 294 N (30 kgf, 66.1 lbf) (w/o ABS)
More than 92 mm (3.6 in.) at 294 N (30 kgf, 66.1 lbf) (w/ ABS)
If incorrect, troubleshoot the brake system.
45287
3.INSTALL LOWER STEERING COLUMN COVER