47201
1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
Apply lithium base glycol grease to a new O-ring.
Install the O-ring onto the brake master cylinder sub-assembly.
Install the brake master cylinder sub-assembly with the 2 nuts.
Using union nut wrench, install the 2 brake tubes onto the brake master cylinder sub-assembly.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Connect the brake fluid level warning switch connector.
31481A
2.CONNECT NO. 1 CLUTCH HOSE (for 3SZ-VE with Manual Transmission)
Connect the No. 1 clutch hose with the clip.
3. FILL RESERVOIR WITH BRAKE FLUID
4.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)
5. BLEED MASTER CYLINDER
6. BLEED BRAKE LINE
7. CHECK FLUID LEVEL IN RESERVOIR
8.INSPECT FOR BRAKE FLUID LEAK