45287
1.REMOVE LOWER STEERING COLUMN COVER
2.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surface.
3.DRAIN CLUTCH FLUID (for 3SZ-VE with Manual Transmission)
31481A
4.REMOVE NO. 1 CLUTCH HOSE (for 3SZ-VE with Manual Transmission)
Slide the clip and disconnect the No. 1 clutch hose from the brake master cylinder sub-assembly.
Slide the clip and disconnect the No. 1 clutch hose from the clutch master cylinder.
31481
5.REMOVE CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE (for 3SZ-VE with Manual Transmission)
Using union nut wrench, separate the clutch tube from the clutch orifice.
Using union nut wrench, separate the clutch tube from the clutch master cylinder.
Remove the clutch reservoir grommet, clutch hose and clutch tube.
47201
6.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
44773F
7.DISCONNECT UNION TO CHECK VALVE HOSE
Slide the clip and disconnect the union to check valve hose from the brake booster
47264D
8.SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
44610
9.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts and remove the brake booster assembly.
Remove the gasket from the brake booster assembly.
Loosen the push rod lock nut and remove the brake master cylinder push rod clevis.