Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.11–2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1557/57  Continuous Overheat Preventive Control  


DESCRIPTION

With its built-in temperature sensor, the power steering ECU monitors the power steering ECU assembly and the motor conditions to prevent them from overheating. If the power steering ECU assembly or the motor overheats in cases such as when the steering wheel is kept at either full lock position for a long time with the vehicle stopped, the power steering ECU assembly will reduce the amount of motor current to protect the motor and the power steering ECU assembly against overheating.

HINT:

The DTCs


DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition
C1557/57 Continuous Overheat Preventive Control
·

When the power steering motor temperature exceeds a predetermined value

·

When the temperature of the power steering ECU exceeds a predetermined value


·

Steering column assembly

·

Power steering ECU


The warning light does not illuminate (normal reset) -

PROCEDURE

1.CONFIRM DTC
a.

Clear the DTCs.

Chassis > EMPS > Clear DTCs
50002 317

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR


b.

Check for DTCs.

Chassis > EMPS > Trouble Codes
50001 317

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
DTC is not output A
C1557/57 is output B
DTC C1557/57 and other DTCs are output C




A

END

B

REPLACE STEERING COLUMN ASSEMBLY

C