Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › 2011.11–2015.08
RM19Y0E _55 Steering _002998 STEERING COLUMN _0015163 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 45250 1.INSTALL STEERING COLUMN ASSEMBLY

a.

Hold up the steering column and install the steering column assembly to the instrument panel reinforcement assembly with the 2 nuts and 2 bolts.

Torque:
18 N*m (186 kgf*cm, 13 ft.*lbf)

NOTICE:
·

Be careful not to damage the brake booster assembly by hitting with the steering main shaft.

·

Be careful not to damage the steering column hole shield.




b.

Align the matchmarks and install the lower side of the steering intermediate shaft assembly onto the steering gear with the new bolt.

Torque:
41 N*m (420 kgf*cm, 30 ft.*lbf)


c.

Install a new bolt on the upper side of the steering intermediate shaft assembly.

Torque:
41 N*m (420 kgf*cm, 30 ft.*lbf)


Hide 45254 2.INSTALL STEERING COLUMN HOLE SHIELD

a.

Install the steering column hole shield to the steering column assembly.


b.

Attach the steering column hole shield to the floor panel.


Hide 89785B 3.INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

Hide 84306 4.INSTALL SPIRAL CABLE SUB-ASSEMBLY (w/ Airbag System)

Hide 84312 5.INSTALL HORN CONTACT PLATE (w/o Airbag System)

a.

Engage the 3 claws and install the horn contact plate onto the steering column assembly.


b.

Connect the connector.


Hide 6.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 89650 7.INSTALL POWER STEERING ECU ASSEMBLY