Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015209 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSTALLATION  


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Check that the front wheels are facing straight ahead.


d.

Attach the 3 claws to install the spiral cable sub-assembly.


e.
B263617

If installing a new spiral cable sub-assembly:

Remove the lock pin.


f.
B266983C01
2.656,2.219 2.875,2.219 2.875,2.219 2.875,2.688 false 1.156,3.063 0.938,3.063 0.938,3.063 0.938,2.885 true 1.177,2.979 1.646,3.167 0.469,0.188 10 *1 (*a) 2.458,2.146 2.667,2.333 0.208,0.188 10 *2
*1 Lock Slider
*2 Airbag Connector (Yellow Colored)
*a Lock Position


Connect the connector to the spiral cable sub-assembly.


g.

Connect the airbag connector (yellow colored) to the spiral cable sub-assembly.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



h.

Check that the lock slider is in the lock position.


Hide 45286B 2.INSTALL UPPER STEERING COLUMN COVER

Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

Hide 84306 4.ADJUST SPIRAL CABLE SUB-ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B298790

Rotate the spiral cable sub-assembly counterclockwise slowly by hand until it feels firm.

NOTICE:

Do not turn the spiral cable sub-assembly by the airbag wire harness.



d.
B298791C01
2.583,1.51 3.083,1.781 3.083,1.781 2.552,1.635 true 3.115,1.708 3.344,1.906 0.229,0.198 10 *a
*a Matchmark


Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the matchmarks.

NOTICE:

Do not turn the spiral cable sub-assembly by the airbag wire harness.


HINT:

The spiral cable sub-assembly can be rotated approximately 2.5 turns to both the left and right from the center position.



Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 9.INSPECT STEERING PAD ASSEMBLY

a.

With the steering pad assembly installed to the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad assembly with a new one:

Cuts, minute cracks or marked discoloration on the steering pad assembly top surface or in the grooved portion.


b.

Make sure that the horn sounds.

If the horn does not sound, inspect the horn system (See page Vehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).