Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM19Y0E _56 Audio / Visual / Telematics _003000 AUDIO / VIDEO _0015166 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Radio Broadcast cannot be Received (Bad Reception)  


PROCEDURE

1.CHECK STEREO COMPONENT TUNER ASSEMBLY
a.

Check if the radio auto-search functions properly.

i.

Tune the radio using the auto-search function and check that it operates normally.

OK:

The radio auto-search functions properly.


Result:
Proceed to
OK
NG





OK

END

NG

2.CHECK OPTIONAL COMPONENTS
2.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as a sunshade film, are installed.

Result:
Result Proceed to
Optional component(s) installed. A
Optional component(s) not installed. B


NOTICE:

Do not remove optional components without the permission of the customer.




A

EFFECT FROM OPTIONAL COMPONENTS

B

3.CHECK INSTALLATION OF ANTENNA GROUND
3.CHECK INSTALLATION OF ANTENNA GROUND
a.

Check that the antenna assembly with holder ground is securely fastened to the body.

OK:

Ground is securely fastened to body.


Result:
Proceed to
OK
NG




OK

4.CHECK ANTENNA ASSEMBLY WITH HOLDER

NG

CORRECTLY INSTALL GROUND

4.CHECK ANTENNA ASSEMBLY WITH HOLDER
a.

Disconnect the antenna plug of the antenna assembly with holder from the antenna cord sub-assembly.


b.

With the ignition switch ACC, turn on the radio and select the AM mode.


c.

Place the tip of a screwdriver on the antenna plug of the antenna cord sub-assembly and check that noise is heard from speakers.

OK:

Noise occurs.


Result:
Proceed to
OK
NG




OK

REPLACE ANTENNA ASSEMBLY WITH HOLDER

NG

5.CHECK ANTENNA CORD SUB-ASSEMBLY
5.CHECK ANTENNA CORD SUB-ASSEMBLY
a.
E232908C02
0.156,0.083 0.458,0.323 0.302,0.24 10 *1
*1 Stereo Component Tuner Assembly


Remove the antenna plug of the antenna cord sub-assembly from the stereo component tuner assembly.


b.

Turn the ignition switch to ACC with the stereo component tuner assembly connector connected.


c.

Place the tip of a screwdriver against the metal terminal of the stereo component tuner assembly and check that noise is heard from speakers.

OK:

Noise occurs.


Result:
Proceed to
OK
NG




OK

REPLACE ANTENNA CORD SUB-ASSEMBLY

NG

REPLACE STEREO COMPONENT TUNER ASSEMBLY