Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015210 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for RHD vehicles.



PROCEDURE

Hide 73970A 1.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Attach the 13 claws to install the instrument panel passenger airbag assembly.


d.

Install the 2 bolts.

Torque:
8.2 N*m (83 kgf*cm, 72 in.*lbf)


e.
B296838C01
0.823,2.781 1.115,2.979 false 2.104,2.948 2.458,2.479 true 1.177,2.927 1.365,3.083 0.188,0.156 10 *1 1.656,2.875 2.115,3.083 0.458,0.208 10 *2 (*a)
*1 Airbag Connector (Yellow Colored)
*2 Lock Slider
*a Lock Position


Connect the airbag connector (yellow colored).


f.

Check that the lock slider is in the lock position.


Hide 55501A 2.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).