If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
89237A
1.INSTALL ECU UNIT BRACKET
Install the ECU unit bracket with the 3 bolts.
89170A
2.INSTALL CENTER AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Install the center airbag sensor assembly with the 3 nuts.
When the ignition switch is first turned to ON after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
Connect the 2 airbag connectors to the center airbag sensor assembly with ECU unit bracket.
When handling the airbag connector, take care not to damage the airbag wire harness.
Engage the 2 clamps.
Check that the connector lock lever is in the lock position.
Check that the center airbag sensor assembly is not loose.
Check that the waterproof sheet is not peeling.
58910C
3.INSTALL FRONT CONSOLE BOX
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5. PERFORM DIAGNOSTIC SYSTEM CHECK
6.CHECK SRS WARNING LIGHT