Use the same procedure for the LHD and RHD vehicle.
The procedure listed below is for the RHD vehicle.
88460
1.INSTALL COOLER CONDENSER ASSEMBLY
Engage the 2 guides and install the cooler condenser assembly into the vehicle.
Do not damage the cooler condenser assembly or radiator assembly when installing the condenser assembly.
If a new cooler condenser assembly is installed, add compressor oil to the condenser assembly as follows.
Add 40 cc (1.35 fl. oz.)
ND-OIL8 or equivalent.
Install the 2 condenser brackets with the 2 bolts.
88716A
2.INSTALL LIQUID TUBE SUB-ASSEMBLY
Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.
ND-OIL8 or equivalent
Install the O-ring onto the liquid tube sub-assembly.
Install the liquid tube onto the cooler condenser assembly with the bolt.
88711
3.INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.
ND-OIL8 or equivalent
Install the O-ring onto the No. 1 cooler refrigerant discharge hose.
Install the No. 1 cooler refrigerant discharge hose onto the cooler condenser assembly with the bolt.
53208A
4.INSTALL HOOD LOCK SUPPORT SUB-ASSEMBLY
88561K
5.INSTALL NO. 2 AIR INLET GRILLE
88561J
6.INSTALL NO. 1 AIR INLET GRILLE
Engage the claw to install the No. 1 air inlet grille.
Install the 4 clips.
Engage the harness clamp.
88561D
7.INSTALL NO. 3 AIR INLET GRILLE
53510
8.INSTALL HOOD LOCK ASSEMBLY
9.INSTALL NO. 1 HOOD LOCK CONTROL CABLE COVER
86520
10.INSTALL LOW PITCHED HORN ASSEMBLY
81150
11.INSTALL HEADLIGHT ASSEMBLY
52119A
12.INSTALL FRONT BUMPER COVER
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14.CHARGE REFRIGERANT
15.WARM UP ENGINE
16.INSPECT FOR REFRIGERANT LEAK