Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR › 2011.11–2014.04
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015234 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
E258200C03
0.958,0.688 1.188,0.438 false 2.219,2.146 2.448,1.698 false 0.792,2.5 1.021,2.313 true 1.354,2.635 1.219,2.302 true 1.125,0.26 1.552,0.594 0.427,0.333 10 *1 1.083,1.031 1.51,1.417 0.427,0.385 10 *2 0.573,0.323 1,0.667 0.427,0.344 10 *b 0.646,2.448 0.958,2.75 0.313,0.302 10 *c 1.26,2.604 1.573,2.906 0.313,0.302 10 *b 1.729,1.583 2.115,1.885 0.385,0.302 10 a 1.719,1.854 2.167,2.146 0.448,0.292 10 b 2.385,1.5 2.833,1.854 0.448,0.354 10 *a 2.083,2.5 2.396,2.802 0.313,0.302 10 c
*1 Plastic Case
*2 Evaporator
*a from Tank
*b Fixed Part
*c Sensor Part
*d Next to Place


Install No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Mark Measurement
a 34.3 mm (1.35 in.)
b 20.9 mm (0.82 in.)
c 48 to 52 mm (1.890 to 2.047 in.)


NOTICE:
·

Be sure to insert the sensor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the sensor one row next to the one that was used previously (*d in the illustration).

·

After inserting the sensor, do not apply excessive force to the wire.

·

Directly insert the sensor until the edge of the plastic case "*1" comes into contact with the evaporator "*2".




Hide 88304A 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY