55910R
1.INSTALL HEATER CONTROL ASSEMBLY
Attach the 2 claws to install the air mix damper control cable sub-assembly.
Attach the 2 claws to install the heater control cable sub-assembly.
Attach the 2 claws to install the air inlet damper control cable sub-assembly.
for RHD:
Route each cables as shown in the illustration.
for LHD:
Route each cables as shown in the illustration.
Connect the mode cable.
Set the dial knob to FACE mode.
Push Mode selector lever against the stopper pin on DEF side, hang the inner cable on the lever and then clamp the outer cable while pulling it in the direction shown in the illustration.
Connect the temperature control cable.
Set the dial knob to MAX COOL.
Push the temperature control lever against the stopper pin on COOL side, hang the inner cable on the lever and then clamp the outer cable while pulling it in the direction shown in the illustration.
| *A | for RHD | *B | for LHD |
Connect the air inlet cable.
Set the dial knob to RECIRC mode.
Push the air inlet selector lever against the stopper pin on RECIRC side, hang the inner cable on the lever and then clamp the outer cable while pulling it in the direction shown in the illustration.
| *A | for RHD | *B | for LHD |
Engage the 2 guides.
Engage the 2 claws and install the heater control assembly.
Connect the 3 connectors.
55420A
2.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55412D
3.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL