55412D
1.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL
55420A
2.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55910R
3.REMOVE HEATER CONTROL ASSEMBLY
Disconnect the 3 connectors.
Disengage the 2 claws.
Disengage the 2 guides.
for RHD:
Detach the 3 claws and disconnect each cables as shown in the illustration.
for LHD:
Detach the 3 claws and disconnect each cables as shown in the illustration.
| *1 | Air Inlet Damper Control Cable Sub-assembly |
Detach the 2 claws and disconnect the air inlet damper control cable sub-assembly.
for RHD:
| *1 | Heater Control Cable Sub-assembly |
Detach the 2 claws and disconnect the heater control cable sub-assembly.
| *1 | Air Mix Damper Control Cable Sub-assembly |
Detach the 2 claws and disconnect the air mix damper control cable sub-assembly.
for LHD:
| *1 | Heater Control Cable Sub-assembly |
Detach the 2 claws and disconnect the heater control cable sub-assembly.
| *1 | Air Mix Damper Control Cable Sub-assembly |
Detach the 2 claws and disconnect the air mix damper control cable sub-assembly.
Remove the heater control assembly.