Use the same procedure for the RHD and LHD vehicle.
85292B
1.REMOVE FRONT WIPER ARM HEAD CAP
85221B
2.REMOVE FRONT WIPER ARM AND BLADE LH
85211B
3.REMOVE FRONT WIPER ARM AND BLADE RH
53446
4.REMOVE HOOD HINGE COVER LH
53445
5.REMOVE HOOD HINGE COVER RH
53383
6.REMOVE HOOD TO COWL TOP SEAL
55781E
7.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
63310
8.REMOVE ROOF HEADLINING ASSEMBLY
It is not necessary to completely remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
Slightly lower the front section of the roof headlining assembly so that the windshield glass can be removed.
75533E
9.REMOVE WINDSHIELD OUTSIDE MOULDING
| *a | Cut |
Using a knife, cut off the moulding as shown in the illustration.
Be careful not to damage the windshield glass.
Be sure to replace the window glass adhesive dam with a new one.
56111A
10.REMOVE WINDSHIELD GLASS
To prevent the windshield glass from dropping when performing this operation, be sure to hold the windshield glass using suction cups.
There are windshield glass stoppers on the windshield glass. Be careful not to damage the windshield glass when cutting off the adhesive.
| *1 | Protective Tape |
Apply protective tape to the installation position of the windshield glass on the vehicle body.
If reusing the windshield glass, put the adhesive tape etc. on the windshield glass and the body panel and put the matchmarks on them before removing the glass.
Install the suction cups to the windshield glass.
| *a | Matchmark |
Place matchmarks on the windshield glass and vehicle body in the locations indicated in the illustration.
Matchmarks do not need to be placed unless the windshield glass is going to be reused.
| *1 | Plastic Sheet |
| *2 | Wooden Block |
| *3 | Windshield Glass Stopper |
| *4 | Piano Wire |
Pass a piano wire between the vehicle body and glass from the interior, as shown in the illustration.
Tie both wire ends to wooden blocks or similar objects that can serve as handles.
Cut off the adhesive by pulling the piano wire around the windshield glass.
When separating the windshield glass from the vehicle, be careful not to damage the vehicle's paint or interior/exterior ornaments.
To prevent the upper instrument panel safety pad from being scratched when removing the windshield glass, place a plastic sheet between the piano wire and upper instrument panel safety pad.
| *1 | Windshield Glass Stopper |
Using suction cups, disengage the windshield glass stopper and remove the windshield glass.
Be careful not to drop the windshield glass.
56117A
11.REMOVE WINDOW GLASS ADHESIVE DAM
Using a scraper, remove the windshield glass adhesive dam.
Be careful not to damage the windshield glass.
Be sure to replace the window glass adhesive dam with a new one.
56115C
12.REMOVE WINDSHIELD GLASS STOPPER
Using a scraper, remove the 2 windshield glass stoppers.
Be careful not to damage the windshield glass.
Be sure to replace the windshield glass stoppers with new ones.