Use the same procedure for the RH side and LH side.
67918E
1.REMOVE REAR DOOR SCUFF PLATE LH (for Full-trim)
67935
2.REMOVE BACK DOOR SCUFF PLATE (for Full-trim)
67881A
3.REMOVE BACK DOOR WEATHERSTRIP (for Full-trim)
73237B
4.REMOVE SHOULDER BELT ANCHOR COVER
73370C
5.SEPARATE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (for Full-trim)
73570
6.SEPARATE REAR NO. 2 SEAT OUTER BELT LH (for Full-trim)
64740C
7.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Full-trim)
62639
8.REMOVE REAR QUARTER FRONT TRIM GARNISH LH (for Full-trim)
62472D
9.REMOVE REAR PILLAR UPPER GARNISH LH (for Full-trim)
62354A
10.REMOVE QUARTER WINDOW INSIDE TRIM LH (for Semi-trim)
Remove the quarter window inside trim LH.
62712
11.REMOVE QUARTER WINDOW GLASS LH
| *1 | Protective Tape |
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
| *a | Matchmark |
Place matchmarks on the quarter window glass LH and vehicle body on the locations indicated in the illustration.
Matchmarks are not necessary if the quarter window glass LH is not going to be reused.
Install the suction cups to the quarter window glass LH.
Pass a piano wire between the vehicle body and glass as shown in the illustration.
| *1 | Piano Wire |
Tie both wire ends to wooden blocks or similar objects that can serve as handles.
When separating the quarter window glass LH from the vehicle, be careful not to damage the paint or interior and exterior ornaments.
Cut off the adhesive by pulling the piano wire around the quarter window glass LH.
Leave as much adhesive on the vehicle body as possible when cutting through the adhesive.
Using suction cups, disengage the 2 clips and remove the quarter window glass LH.
Be careful not to drop the glass.
75642
12.REMOVE QUARTER WINDOW FRONT OUTSIDE MOULDING LH
Remove the quarter window front outside moulding LH from the quarter window glass LH.
62785A
13.REMOVE QUARTER WINDOW GLASS SPACER
Using a scraper, remove the quarter window glass spacer from the quarter window glass LH.
Be careful not to damage the quarter window glass.
14.REMOVE NO. 1 QUARTER WINDOW GUIDE PIECE PIN
Using a scraper, remove the No. 1 quarter window guide piece pin from the quarter window glass LH.
Be careful not to damage the quarter window glass LH.