The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
73237B
1.REMOVE SHOULDER BELT ANCHOR COVER
| *1 | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the shoulder belt anchor cover.
Use the same procedure as for the both the rear No. 1 seat outer belt assembly side and rear No. 2 seat outer assembly side.
73360C
2.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY
Loosen the bolt and disconnect it with the shoulder anchor.
Loosen the bolt and disconnect it with the floor anchor plate.
73560
3.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY (for Full-trim)
Loosen the bolt and remove it with the floor anchor plate.
73560
4.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY (for Semi-trim)
67917C
5.REMOVE REAR DOOR SCUFF PLATE (for Full-trim)
67935
6.REMOVE BACK DOOR SCUFF PLATE (for Full-trim)
64730B
7.REMOVE DECK TRIM SIDE PANEL ASSEMBLY (for Full-trim)
73431A
8.REMOVE REAR SEAT BELT RETRACTOR COVER (for Semi-trim)
Remove the 4 clips.
Disengage the 4 claws and remove the 2 rear seat belt retractor covers.
62520P
9.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH (for Semi-trim LH Side)
62510P
10.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH (for Semi-trim RH Side)
73360C
11.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY
Loosen the bolt and disengage the 2 guides to remove the rear No. 1 seat outer belt assembly with the bolt.