Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR › from 2014.04
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015234 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the RHD vehicles.



a.
E258200C04
0.813,0.896 1.188,0.438 true 0.76,2.448 0.958,2.26 true 1.26,2.563 1.083,2.188 true 0.5,0.896 0.354,0.594 false 0.271,0.406 0.698,0.74 0.427,0.333 10 false b 0.615,0.344 1.042,0.688 0.427,0.344 10 false X 0.604,2.448 0.917,2.75 0.313,0.302 10 false *b 1.26,2.594 1.573,2.896 0.313,0.302 10 false *a 1.75,1.583 2.135,1.885 0.385,0.302 10 false A 1.75,1.896 2.198,2.188 0.448,0.292 10 false B 2.083,2.5 2.396,2.802 0.313,0.302 10 false C 1.229,0.24 1.656,0.573 0.427,0.333 10 false a
*a Secured Part
*b Sensor Part


Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Mark Measurement
A 34.3 mm (1.35 in.)
B 20.9 mm (0.82 in.)
C 50.0 mm (1.97 in.)


NOTICE:
·

Be sure to insert the sensor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the sensor one row next to the one that was used previously (X in the illustration).

·

After inserting the sensor, do not apply excessive force to the wire.

·

Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".




Hide 88304A 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (for RHD)

Hide 88304A 3.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (for LHD)