Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › from 2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015138 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  INSTALLATION  


PROCEDURE

Hide 44547B 1.INSTALL BRAKE ACTUATOR BRACKET CUSHION

a.

Install the 3 brake actuator bracket cushions.


Hide 44510 2.INSTALL BRAKE ACTUATOR ASSEMBLY

a.

Using a 6 mm hexagon wrench, install the brake actuator assembly to the brake actuator bracket assembly with the 3 hexagon bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 3.INSTALL BRAKE ACTUATOR WITH BRACKET

a.

Install the brake actuator with bracket with the 3 bolts.

Torque:
19.5 N*m (199 kgf*cm, 14 ft.*lbf)


b.
C333885C01
1.802,2.854 2.115,3.01 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a 10 mm union nut wrench, install each brake line into the correct position of the brake actuator assembly.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)):

13.4 N*m (137 kgf*cm, 10 ft.*lbf)




c.
C333886

Connect the connector and lock the lock lever as shown in the illustration.

NOTICE:

Make sure that the connector is locked securely.



Hide 4. FILL RESERVOIR WITH BRAKE FLUID

Hide 47201 5.BLEED MASTER CYLINDER

Hide 6.BLEED CLUTCH LINE (for 2NR-VE with Manual Transmission)

Hide 8. CHECK FLUID LEVEL IN RESERVOIR

Hide 9.INSPECT FOR BRAKE FLUID LEAK