Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2015.08–2016.09
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015150 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Apply lithium base glycol grease to a new O-ring.


b.

Install the O-ring onto the brake master cylinder sub-assembly.


c.

Install the brake master cylinder sub-assembly with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


d.
C332246C01
1.677,1.406 1.875,1.583 0.198,0.177 10 true *a
*a Torque Wrench Fulcrum Length


Using a 10 mm union nut wrench, install the 2 brake tubes onto the brake master cylinder sub-assembly.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)):

13.4 N*m (137 kgf*cm, 10 ft.*lbf)




e.

Engage the clamp and connect the brake fluid level warning switch connector.


Hide 31481A 2.CONNECT NO. 1 CLUTCH RESERVOIR HOSE (for 2NR-VE with Manual Transmission)

a.

Connect the No. 1 clutch reservoir hose with the clip.


Hide 3. FILL RESERVOIR WITH BRAKE FLUID

Hide 4.BLEED CLUTCH LINE (for 2NR-VE with Manual Transmission)

Hide 5. BLEED MASTER CYLINDER

Hide 6. BLEED BRAKE LINE

Hide 7. CHECK FLUID LEVEL IN RESERVOIR

Hide 8.INSPECT FOR BRAKE FLUID LEAK