Home › Power Source / Network › POWER DISTRIBUTION › MAIN BODY ECU(for RHD) › from 2015.08
RM19Y0E _57 Power Source / Network _041460 POWER DISTRIBUTION _0192577 MAIN BODY ECU(for RHD) A

POWER DISTRIBUTION  MAIN BODY ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55301 3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55545 4.REMOVE FUSE BOX OPENING COVER

Hide 82600 5.REMOVE FUSE BLOCK ASSEMBLY

a.
B414220

Remove the 2 bolts.


b.
B417776

Disconnect each connector and disengage the clamp.


c.
B414222

Pull down the lock lever to disconnect the connector.


d.
B417777

Disengage the 3 clamps.


e.

Disconnect each connector to remove the fuse block assembly.